@ -16,7 +16,7 @@ To get your micro-controller to do what you want, it needs some instructions. If
#### Prerequisites
#### Prerequisites
* Arduino Uno or Duemilanove (w/ an ATmega328, not an older board with an ATmega168)
* Arduino Uno or Duemilanove (w/ an ATmega328, not an older board with an ATmega168)
* ATtiny45 or ATtiny85 (8-pin DIP package) attiny85V-10pu(1.8v-5.5) NOT the attiny85-20pu(2.7-5.5) > consumes to much power
* ATtiny45 or ATtiny85 (8-pin DIP package), the attiny85-20pu(2.7-5.5) (20Mhz) is not so load, will test out attiny85V-10pu(1.8v-5.5) (10Mhz). This means setting the bootloader fuses at 8Mhz and speeding up the soundfiles times two.
* 10 uF capacitor
* 10 uF capacitor
* Breadboard
* Breadboard
* 8x jumper wires
* 8x jumper wires
@ -142,7 +142,7 @@ Optional
#### Formatting sound-files
#### Formatting sound-files
Place (up to 48 kHz, 8-bit, mono) PCM .wav files on a FAT (32) formatted SD card inside folder called "wav".
Place (up to 48 kHz, 8-bit, mono) PCM .wav files on a FAT (32) formatted SD card inside folder called "wav".
NOTE: When flashing the ATtiny at 16Mhz the files play a bit to fast. You can flash a 8MHz bootloader, but this requires you to speed up the sound files times two. This seemed to sound better..but yeh...you already know what it is...
NOTE: When flashing the ATtiny at 16Mhz the sound files seem to play a bit fast. You can flash a 8MHz bootloader, but this requires you to speed up the sound files times two ('-speed 2'). This IS required when using an ATtiny85 10pu (runs at max 10Mhz).
